Maybe your press brake controller has already implemented the automatic detection of the sensor mounting position X, R and Angle. Please ask your vendor.
If not, you can use the same VC Update-Tool also for detecting the parameters X, R and Angle:
Just select “Sensor Mounting Position”. In the output window you will see the parameters X, R and Angle. Repeat this step for the front and back sensor IP. Then transfer the values to your press brake controller.
| Info |
|---|
Please take care, that the mounting angle of the sensor has to be in the range of 20 – 50 degrees to the vertical line. |
Before you start the detection, please mount in front of the laser beam the VC Press Break Mounting Detection Tool from Vision Components (VK000563 / VC PB-MDT (mounting detection tool).
In addition you will get the result of the “Mounting Detection Tool”-Angle (135,0 +/- 0.2 degrees) and you can check, if your sensor works correctly.
