/
10.2 Angle measurement

10.2 Angle measurement

Owned by Anida Salaj (Unlicensed)
Last updated: Nov 22, 2022 by Wilhelm Scheermann

If you want to measure angles send the following parameters:

  1. Product Parameter (CMD_RECEIVE_PRODUCT_DATA - ID 40)

    J00_ProductType = 1 J00_PolygonNr = 2 J00_PolygonPoint_X00_MM = -500.0 J00_PolygonPoint_Z00_MM = 0.0 J00_PolygonPoint_X01_MM = 500.0 J00_PolygonPoint_Z01_MM = 500.0

     

  2. Sensor Parameters (CMD_RECEIVE_SENSOR_DATA - ID 43)

    DataMode = 8 NbrLines = -1

You will permanent get a result strings like:

JOB 0.0001: Phi=156.36 Cx=00.4011 Cy=-0.9161 B=-0104.19 LAlgo=2 Points=0501 DetLen=042.6 Filter=100 dPhi=0.03 Error=0 Sh=0012us Gain=000 TimeStamp=0000006468167ms

 

For accuracy reason ignore the first 5-10 angles after a new plate or ROI is defined, as the auto exposure takes some images for adaption.

Related content