Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 9 Current »

Table of Contents

  1. General Information

1.1 Hardware Compatibility

1.2 Technical Specification

1.3 Connectors

1.3.1 Jumper field

1.3.2 Connecting the board

2. Ordering Information

2.1 MIPI camera module order numbers

2.2 Order numbers of MIPI camera module Accessories

3. Appendix A: Dimensions MIPI Repeater Board

1 General Information

1.1 Hardware Compatibility

The VC MIPI Repeater Board is intended to be inserted into a VC MIPI signal link. It allows extending the cable length between the VC MIPI sensor and the host processor. It also makes it possible to access both hardware trigger input and flash output signals from the VC MIPI Module without soldering.

1.2 Technical Specification

Technical Data

Component / Feature

Specification

Number of lanes

1–4 depending on sensor module

MIPI speed

max. 1.5Gbps

Flash output signal

3.3V LVCMOS

Trigger input signal

3.3V LVCMOS

Storage Conditions

Temperature: -20 to +60 deg C, Max. humidity: 90%, non condensing.

Operating Conditions

Temperature: 0 to +50 deg C, Max. humidity: 80%, non condensing.

Power Consumption

approx. 200mW @ 3.3V drawn from the host over the VC MIPI Cable

1.3 Connectors

1.3.1 Jumper field

The board contains a jumper field with access to

  • the trigger input and flash output signals of the VC MIPI sensor, as well as

  • GND and 3.3V.

If the access to trigger and flash signals is not needed it is recommended to connect the signals flash from sensor and trigger to sensor of the sensor side VC MIPI cable with the host side VC MIPI cable using jumpers.

If you need to access to the signals, remove the jumpers and connect the signals with a 2mm MOLEX cable header with the jumper field. Make sure to use the GND pin as a reference level. If necessary it is possible to supply the 3.3V to your circuit from the VC MIPI Repeater Board.

1.3.2 Connecting the board

Connect the VC MIPI Repeater Board as shown in the figure Connecting the board:

To the left we have the 22 to 22 Pin Flexible Printed Circuit (FPC) Cable (EK003260). The cable needs to be showing the label CPU Side at this position. Further to the left the MIPI Camera module should be connected.

To the right we can either have the same 22 to 22 Pin FPC Cable or the 22 to 15 Pin FPC Cable (EK003261). At this position the cable needs to be showing the label MIPI Module Side. Further to the right the host CPU should be connected.

Make sure to connect the board as shown in the image and described at the text. Otherwise the hardware will be damaged.

2 Ordering Information

2.1 MIPI camera module order numbers

VC MIPI camera modules

Order Number

Product ID / Service description

VK003318

VC MIPI Repeater Board — do not forget to order the appropriate FPC cable!

2.2 Order numbers of MIPI camera module Accessories

Accessories for VC MIPI camera modules

Order Number

Product / Service description

EK003260

Flexible Printed Circuit (FPC) Cable, 200 mm: 22 to 22 Pin

EK003261

Flexible Printed Circuit (FPC) Cable, 200 mm: 22 to 15 Pin

3 Appendix A: Dimensions MIPI Repeater Board

  • No labels