Skip to end of metadata
Go to start of metadata

You are viewing an old version of this content. View the current version.

Compare with Current View Version History

« Previous Version 18 Current »

CONTENT

  1. Sensor Type

  2. IP Address

  3. Sensor Mounting
    3.1 Measure Angle > 120 degrees

  4. Mounting Position X,R and Angle
    4.1 Automatic detection of mounting
    4.2 Manual detection of mounting position

  5. Recommended Mounting Positions
    5.1 Mounting Position for dies V6 – V70
    5.2 Mounting Position for dies V6 – V160
    5.3 Mounting Position for dies V60 – V200

  6. Typical Accuracy

  7. Camera Connectors

  8. Strain-gauges

  9. GUI - VC Smart Shape

  10. Communication Steps for Bending
    10.1 Sensor Initialisation
    10.2 Angle measurement
    10.3 Stop angle measurement

  11. Angle Measure Programs (ProductType)
    11.1 Measure X, R and Angle with the MDT (ProductType 1002)
    Necessary Parameter
    Sensor result output of the MDT detection

    11.2 Measure the Angle in a rectangle ROI (ProductType Calculating the ROI
    Necessary Parameter
    Sensor result output of the angle detection

    11.3 Optional - Measure Angle in polygon ROI (ProductType 1)
    Calculating the ROI
    Necessary Parameter
    Sensor result output of the angle detection

    11.4 Converting Machine Coordinates to Sensor Coordinates
    11.5 Calculate Plate Angle
    Two sensor detection (recommended)
    Front sensor detection (not accurate, if plate is asymmetric)
    Back sensor detection (not accurate, if plate is asymmetric)

  12. Useful adjustable Parameters for bending

  13. Parameter Error List

Kontakt einfügen

  • No labels